Parkside PSS 250 A1 Bedienungsanleitung PDF herunterladen (Seite 41)

41 GB

OperationGeneral safety advice for electrical power tools / Operation

metals or metal objects left in wood. This can hap-

pen especially if the wood dust has paint particles

on it or is mixed with other chemical substances and

the sanded material is hot after extensive working.

You should therefore avoid overheating of products

being sanded as well as the appliance and always

empty the dust collection box

or the dust bag

of the vacuum cleaner before work pauses.

Wear a dust mask!

Vacuuming dust with the dust

collection box

Attach the dust collection box:

Push the dust collection box

on to the device.

Remove the dust collection box:

Press the release button(s)

and pull the dust

collection box

oﬀ the device.

NOTE: Always empty the dust collection box

in due time and shake any remaining dust out; this

will ensure optimal vacuum performance.

Dust extraction using an external

vacuum extraction device

Connecting:

For vacuum dust removal using a vacuum

cleaner, push the suction hose of a vacuum

cleaner approved for use as a dust extraction

device (e.g. a workshop vacuum cleaner) into

the connection

– see Fig. D.

NOTE: If it is necessary to use the reducer

piece

, push the reducer piece into the con-

nection

Removing:

Pull the hose of the dust extraction device oﬀ

the connection

or oﬀ the reducer piece

if one is used.

Instructions, tips and tricks

Move the oscillating sander parallel, in ﬂat

circles or alternating between lengthwise and

side-to-side motions.

Do not press down with the oscillating sander.

The sanding sheets become clogged, which re-

duces the sanding performance.

Clean the sanding sheet

occasionally with

the vacuum cleaner.

The removal performance and therefore the re-

sult of your work are determined by the correct

selection of the speed and sanding sheet

grit.

Never sand diﬀerent materials with the same

sanding sheet

(e.g. wood then metal).

The following table oﬀers some values, which are

for information only and may simplify the selection

of a sanding sheet

Wood Sanding sheet / Grit

Sanding of wood 40–240

Pre-sanding, e.g. of

rough, unplaned

beams and boards

40, 60

Surface sanding 80, 100, 120

Fine sanding of hard

woods

180, 240

Paints / Lacquers Sanding sheet / Grit

Sanding of paint /

lacquer coats or

base coats such

as ﬁller and

smoothing com-

pound

40–320

Sanding oﬀ paint 40, 60

Sanding oﬀ primer

coats

80, 100, 120

Final sanding of base

coats before painting

180, 240, 320

1 2 ... 36 37 38 39 40 41 42 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Parkside PSS 250 A1 Bedienungsanleitung Seite 41

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schleifmaschinen Parkside PSS 250 A1