Parkside PWS 125 A1 Bedienungsanleitung PDF herunterladen (Seite 47)

47 GB

Use / Use of accessoriesGeneral safety advice for electrical power tools / Use

Switching off:

Release the ON / OFF switch

2

again.

Q

Setting the speed

Select the desired speed before use to suit your

purpose. Turn the speed preselector wheel

10

to the desired setting. The required rotational

speed depends on the material being worked

and the working conditions and can be deter-

mined by means of a practical test.

The table below shows some recommended

settings (for guidance only and given without

liability) for a number of common applications.

The accessories mentioned may not all be sup-

plied as standard with the product. Sawing stone

is only permitted with the use of a cutting guide

(accessory).

Preselected rotation speed:

Material

Application

Tool Setting

Plastic,

varnish

Polishing Lambswool

bonnet

1

Fine ﬁnish

Felt polishing

disc

1

Metal Fine ﬁnish Buﬃng disc 1

Paint

removal

Sanding sheet 2–3

Wood,

metal

Brushing,

derusting

Cup brush,

sanding sheet

3

Metal,

stone

Grinding /

abrading

Grinding disc 4–6

Metal Roughing /

grinding

Roughing /

grinding disk

6

Stone Cutting Cutting disc

and cutting

guide

6

Metal Cutting Cutting disc 6

Q

Changing a disc

Always wear protective gloves

when changing cutting or roughing /

grinding discs.

Press the spindle lock button

9

only after the

mounting spindle

7

has reached a standstill,

Fig. A.

Press the spindle lock button

9

to block the

drive.

Release the clamping nut

6

using the spanner

11

, Fig. B.

Place the roughing, grinding or cutting disc on

to the mounting ﬂange

8

with its labelled side

facing towards the device.

Then replace the clamping nut

6

, with its

raised side facing upwards, on to the mounting

spindle

7

.

Press the spindle lock button

9

to block the

drive.

Tighten the clamping nut

6

again with the

spanner

11

.

Note: Replace a new disc immediately if it runs

unevenly or vibrates after being exchanged.

After replacing a disc let the device run under

no load for 30 seconds as a safety check.

Look out for unusual noises or generation of

sparks.

Check that all the fastenings are correctly

attached.

Pay attention to see that the arrow showing the

direction of rotation on the cutting or roughing /

grinding discs (including diamond cutting discs)

corresponds with the direction of rotation of the

device (see arrow on the head of the device).

Q

Use of accessories

Q

Cutting / roughing discs

You can use the following cutting or roughing/

grinding discs with this device:

Dimensions: ø 125 x 22.2 mm

to max. 6 mm thick

(depressed centre)

Speed: min. 12000 rpm

Circumferential speed: 80 m / sec

1 2 ... 42 43 44 45 46 47 48 49 50 51

Kommentare zu diesen Handbüchern

Keine Kommentare