Parkside PABS 12 A1 Bedienungsanleitung PDF herunterladen (Seite 7)

7 GB

Introduction / General safety advice for electrical power tools

Technical Data

Cordless Drill PABS 12 A1:

Nominal voltage: 12 V

Idle-running speed: 1st gear: 0–400 min

-1

2nd gear: 0–1300 min

-1

Drill chuck

clamping range: max. 10 mm

Maximum

drill diameter:

Steel: 8 mm

Wood: 20 mm

Battery pack PABS 12 A1-1:

Type: LITHIUM-ION

Nom. voltage: 12 V

Capacity: 1300 mAh

PABS 12 A1-2 Fast Charger:

INPUT

Nominal voltage: 230 V∼ 50 Hz

Nominal power: 27 W

OUTPUT

Nominal voltage: 12.6 V

Charging current 1500 mA

Charging time: approx. 60 min

Protection class: II /

Noise / vibration data:

Measured values for noise are determined in accord-

ance with EN 60745. The A-weighted noise level

of the electrical power tool are typically:

Sound pressure level: 67.2 dB(A)

Sound power level: 78.2 dB(A)

Uncertainty K: 3 dB

Wear ear protection!

Total vibration (vector sum of three directions) is

calculated in accordance with EN 60745:

Drilling in metal: Vibration emission value

h,D

= 1.507 m / s

uncertainty K = 1.5 m / s

Screwing: Vibration emission value

= 0.747 m / s

uncertainty K = 1.5 m / s

The vibration level speciﬁed in

these instructions was measured in accordance with

an EN 60745 standardised measurement process

and can be used to compare equipment. The vibra-

tion emission value speciﬁed can also serve as a

preliminary assessment of the exposure.

The vibration level will change according to the ap-

plication of the electrical tool an in some cases may

exceed the value speciﬁed in these instructions. Re-

gularly using the electric tool in such a way may

make it easy to underestimate the vibration.

Note: If you wish to make an accurate assessment

of the vibration loads experienced during a particular

period of working, you should also take into account

the intervening periods of time when the device is

switched oﬀ or is running but is not actually in use.

This can result in a much lower vibration load over

the whole of the period of working.

General safety advice for

electrical power tools

Read all the safety advice

and instructions! Failure to observe the safety

advice and instructions may result in electric shock,

ﬁre and / or serious injury.

Keep all the safety advice and instructions

in a safe place for future reference!

The term “electrical tool” used in the safety advice

refers to electrical tools powered by mains electrici-

ty (by means of a mains lead) and electrical tools

mains lead).

1. Workplace safety

a) Keep your working area clean and

well lit. Untidy or poorly lit working areas

can lead to accidents.

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Kommentare zu diesen Handbüchern

Keine Kommentare

Parkside PABS 12 A1 Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Parkside PABS 12 A1